Use your fingers to install the bottom bolt into the rebound damper shaft - 2-3 turns is enough, then pull down on the bottom bolt to extend the shaft. Then insert a 2.5mm hex wrench into the bottom of the rebound shaft and turn it counter-clockwise until it stops. Open the rebound assembly by pulling down on the rebound shaft extend it. RCT3 Only: Use a 2.5mm hex wrench to remove the low speed compression needle. RC Only: Use needle-nose pliers to remove the bleed plug from the compression adjuster. RCT3 Only: Use needle-nose pliers to remove the low speed compression adjuster from the compression top cap. RC Only: Use small circlip pliers to remove the retaining ring from the bleed plug. RCT3 Only: Use small circlip pliers to remove the retaining ring from the low speed compression adjuster. Use a work stand to secure the Charger Damper by the cartridge tube just beneath the rubber bladder.ĭo not use excessive clamping force or secure the Charger Damper by its rubber bladder. Compressing the fork will expose more of the Charger Damper for you to get a hold of. It can sometimes be difficult to remove the Charger Damper from the fork. Remove the Charger Damper assembly from the upper tube and wipe the whole damper assembly over with a paper towel or rag Be careful not to let the socket slip and damage the fork. Use a 30mm socket wrench to loosen the damper top cap. Remove the low speed adjuster knob from the fork. ![]() RC Only: Use a 4mm hex wrench to remove the knob retaining nut. Use a 6mm socket wrench to loosen the compression mode adjuster knob retaining nut. RCT3 Only: Use a 2mm hex wrench to remove the low speed adjuster knob screw and then remove the low speed adjuster knob. Use a rag to catch the small amount of suspension oil which will exit from the hole in the lower leg. Use a 5mm hex wrench to remove the bottom bolt. Use a 2.5mm hex wrench to loosen the set screw and remove the rebound adjuster knob located at the bottom of the drive side fork leg. We also supply 100ml Genuine RockShox 3wt Suspension Fluid with every kit. Our very own RockShox Charger Damper Bleed Kit contains the Charger Damper bleed tip and a secure locking syringe to eliminate leaks and keeps the fluid in the system instead of all over your workshop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |